Craft Colors Strong+ Floor Paint is a one-component, water-dilutable special coating based on acrylate, ideal for various types of floor surfaces in both indoor and outdoor areas subjected to normal pedestrian traffic. This coating is tough, flexible, and abrasion-resistant, providing long-lasting protection. Additionally, it is easy to apply, virtually odorless, and environmentally friendly as it is water-dilutable.

Special coating for all types of floors in indoor and outdoor areas with normal pedestrian traffic, such as basement floors, cement plinths, screeds, concrete stairs, plaster, masonry, wood, etc. Avoid standing water and prolonged moisture exposure. Not suitable for garage floors, as hot car tires can cause the coating to stick!

Acrylate copolymer dispersion, titanium dioxide, inorganic pigments, calcitic and silicate fillers, water, glycols, additives, preservatives. Contains the biocide CIT/MIT (3:1) to maintain storage stability.

Do not apply at temperatures below +8°C, nor in high heat (direct sunlight). The substrate must be clean, dry, grease-free, stable, and absorbent. Moisture rising from below must be excluded. Outdoors, remove moss and algae. Concrete and screed surfaces must be cured for at least 4 weeks. Roughen smooth cement surfaces. Mechanically remove cement slurry and sinter layers, as well as friable surface layers. Check old coatings for compatibility (trial application). Remove loose coatings, sand down well-adhering old coatings (wear a dust mask). Prime critical and highly absorbent substrates with a solvent-free primer. Do not apply on horizontal surfaces exposed to permanent moisture. Balcony floors should have a slight slope.

When using multiple containers, check batch consistency. Stir well before use and apply evenly.

• Prepare the substrate as needed.
• Apply 1 coat of primer with LF Primer.
• For raw wood, apply wood primer (for mildew protection) on the outside.
• Apply 2-3 coats undiluted.

• Prepare the substrate as described above.
• Apply 1-2 undiluted coats.

Roller or paintbrush

Clean tools immediately after use with water and soap.

(at +20°C, 65% relative humidity)

Final surface durability is reached after approx. 3 days. Avoid mechanical load on surfaces and splashing water during this time.
Drying is significantly influenced by ambient temperature and humidity. Low temperatures and high humidity may delay drying.

For cleaning and maintaining painted surfaces, we recommend neutral household cleaners. Please avoid abrasive sponges, scouring milk, aggressive cleaners, etc.

Recycle only completely emptied containers. Dispose of liquid material residues at the collection point for old paints.

Store in a cool, frost-free place in the unopened original container. Close tightly after use.

These technical instructions are for informational purposes only and are based on our research and experience. They may be changed by us without prior notice to comply with the latest technological standards. We cannot assume responsibility due to the wide range of influences during application and processing.

The stated consumption values are non-binding guidelines for each coat on smooth substrates. Exact consumption values should be determined on the surface to be coated, taking into account all preparatory work, through a trial application.

P101: If medical advice is needed, have the packaging or label ready. P102: Keep out of reach of children. P103: Read all instructions carefully and follow them.

EUH208: Contains 1,2-benzisothiazol-3(2H)-one; reaction mass of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2H-isothiazol-3-one (3:1). May cause allergic reactions. EUH210: Safety data sheet available on request.